2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。     

Modelling the effect of changing precipitation inputs on deep soil water utilization

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.     

内蒙古鲁新井田水文地质条件研究

矿产资源开发导致了地下水失衡,地下水失衡又给矿产开发造成了极大的安全隐患,近年来,矿产资源开发与地下水环境保护之间的矛盾愈发凸显。通过对内蒙古鲁新井田典型的水文地质条件进行分析研究,分析采矿导致地下水失衡机理,深入剖析矿井开采充水条件及矿山开发对地下水环境的影响,合理提出了促进矿产开发与地下水保护相互协调的对策建议,为实现"采矿保水"协调统一提供了基础地质依据。为类似地区矿产开发过程中遵循自然规律,趋利避害,保障生产安全,保护地下水环境安全,实现资源绿色开发有较好的指导借鉴作用。     

鄂尔多斯盆地宜川地区二叠纪孢粉化石组合特征

通过对延长油矿延223井晚古生代孢粉组合研究以及古植被的恢复,探讨了该区晚古生代孢粉植物化石组合的地层学和古气候意义。根据孢粉化石主要属种的时代分布及其在各样品中百分含量的规律性变化,自下而上建立了3个孢粉组合:Gulisporites cochlearius-Laevigatosporites minimus组合、Sinulatisporites-Florinites组合和Lueckeisporites permianus-Platysaccus radialis组合。根据对划分孢粉组合的特征分析,通过与邻区及华北地区晚古生代孢粉组合的对比,探讨了孢粉组合的时代意义。通过孢粉组合,推测了相应时期的古植被类型,并与前人在相同地质时期所建立的大植物化石带进行了对比,分析了各地质时期植被的兴起、发展、繁盛以及衰退绝灭的历史过程,研究区二叠纪植物群属于典型的华夏植物群,反映了一种温暖潮湿的热带雨林气候,二叠纪晚期随着松柏类植物所占比例的增加,气候有变干旱的趋势。     

深水铺管船托管架疲劳分析及动态监测点选取研究

作为S型铺管作业的关键性装备,托管架长期承受着交变载荷的作用,随着海洋开发向超深水发展,结构疲劳破坏问题不容忽视。采用疲劳谱分析的方法并结合线性累积损伤理论,对托管架结构频域下的变形进行了分析,计算了正常海况下和极端海况下托管架疲劳损伤度并对疲劳寿命进行了评估。研究发现托管架在正常海况下作业符合安全要求,在极端海况下局部结构会受到破坏。并从托管架结构安全监测角度,筛选了结构疲劳分析关键点位,为监测点位的选取提供了依据。     

超基性岩中含铜、钴块状硫化物矿床——德尔尼铜矿成因新认识

长期以来对德尔尼铜矿的成因存在着不同认识。从矿石组成和结构、构造来看,应属典型的块状硫化物矿石,矿床亦应属于含铜黄铁矿型矿床。但从其地质产状来看又与一般的黄铁矿型矿床大不相同,与一般的岩浆熔离铜镍硫化物矿床也有较多差异。这就是本矿床类型独特之处。近年来通过工作又取得一些新资料,特别是超基性岩和矿石的同位素年龄数据。本文在综合新老资料基础上,提出新看法,认为该矿床形成于上地幔,再就位于地壳浅部。其成因类型暂定为:“深部熔离—构造侵位矿床”。鉴于本矿床与一般块状硫化物矿床相比有其独特性,建议命名为“德尔尼型”。     

地下洞库勘察中的深斜孔钻探和压水试验技术

青岛市黄岛区拟建设海底地下油气储藏库,前期地质勘察工作要求施工倾角45°、深220m的取心钻孔4个,并在孔内分段进行压水试验.本文介绍了如何利用XY-4型金刚石小口径钻机施工基岩深斜孔及压水试验技术.     

Optimization of grid-drilling using computer simulation

A computer simulation method has been developed to find efficient drilling grids for mineral deposits. A well-known ore deposit is used as a model to develop an efficient pattern for undiscovered ore bodies in the same area or in other prospects where similar geometry is suspected. The model for this study is the Austinville, Virginia deposit, a Mississippi Valley-type deposit composed of 17 ore bodies totaling 34 million short tons (30 million metric tons). The method employs a computer program that simulates drilling the model deposit with different patterns, including various levels of follow-up drilling. Follow-up holes are drilled in fences at one half the original spacing around holes in the grid that show ore-grade mineralization. Each pattern is drilled 100 times from random starting locations to provide a range of outcomes of drilling, including the best, worst, and most likely. For this study, patterns of 100 drill holes were composed of 10 fences spaced 1000–5000 feet (305–1524 m) apart, each with 10 holes spaced 200–1000 feet (61–305 m) apart. In all, 25 grids were used with zero to three levels of follow-up drilling. The 600/2000 grid, with drill holes spaced 600 feet (183 m) apart in fences spaced 2000 feet (610 m) apart, was compared with the 200/5000 grid because they represented contrasting outcomes. The 600/2000 grid penetrated many ore bodies consistently but with few multiple hits to individual ore bodies; whereas the 200/5000 grid inconsistently penetrated few ore bodies with many multiple hits. The 600/2000 grid was more efficient than the 200/5000 grid at hitting large ore bodies of 1,000,000 short tons or greater (900,000 metric tons or greater) and was made more effective by adding one cycle of follow-up drilling. The 600/2000 grid had a 97% chance of hitting one or more large ore bodies with at least one drill hole per ore body, and the 200/5000 grid had a 64% chance. Once hit, there was an 82% chance that the largest ore body would be penetrated by three or more holes when using the 600/2000 grid and an 88% chance using the 200/5000 grid.     

Formation Pressure Evaluation Method for Single Well

The paper deals with the methods of formation pressure evaluation for a single well by using the very common ac-cepted parameters, such as drilling exponent , and flowline temperature , etc. which is part of compiling the end well report.